|
|
|
|
|
#2
06-25-2007, 08:10 PM
|
|||
|
|||
|
That's OK.......don't forget the filter and drain the Torque Converter..
|
|
#4
06-25-2007, 08:14 PM
|
|||
|
|||
|
Closer to 7 b/c of filter change and you are dropping the pan...[ which you want really clean before you put it back on]
|
|
#5
06-25-2007, 08:23 PM
|
|||
|
|||
|
Cool, Thanks for the help. Here's what I have: New Pan Gasket, Transmission Filter, Copper washer for drain plug on pan, and also a new transmission torque converter drain plug...
I have done an ATF service twice before on my Ford Taurus and both times it was really pretty simple stuff... I just want to use proper fluids, etc. as to not screw anything up... Thanks again, -GH
|
|
#6
06-25-2007, 08:27 PM
|
|||
|
|||
|
That ATF would be fine, I have used it before.
__________________
08 W251 R350 97 W210 E320 91 W124 300E 86 W126 560SEL 85 W126 380SE Silver 85 W126 380SE Cranberry 79 W123 250 78 W123 280E 75 W114 280
|
|
#7
06-25-2007, 10:51 PM
|
||||
|
||||
|
Not sure if it applies in your case, but in mine, the transmission pan uses a copper washer; the torque converter uses an aluminum washer.
See Gilly's comments in the following thread: transmission fluid change
__________________
Mike Murrell 1991 300-SEL - Model 126 M103 - SOHC "Fräulein" Last edited by Mike Murrell; 06-25-2007 at 10:58 PM.
|
 |
| Bookmarks |
|
|
Linear Mode
