Dear community
I have just removed the driver side ETA and found the wire isolation in terrible condition; they need to be replaced. Unfortunately I have cut the wires before making a diagram and the diagram I have is for passenger side only. The wire isolation is completly gone and it is impossible to read the colour codes anymore. So I desperately need a wiring diagram that shows board connections (a, b,c, etc) to connector pin location (1,2,3, etc.).
Would very much appreciate if somebody out there could help with this.
The car is a very nice S600, 1995, WDB 1400571A267885. The ETA p/n is 000 141 87 25 (Mercedes p/n) or 0 205 003 028 (Bosch p/n).
Many thanks!
Philippe

http://v12uberalles.com/throttle_actuator_rewire.htm

Thanks for the hint; I know this webpage and it is extremly helpful, but unforthunately it describes the passengerside ETA wiring only, but not driverside and that's the information I am looking for.

Read this thread. At the very end is the driver's side pin out.
Electronic Accelerator (EA) - Who's got the best price?

Hi again, sorry but I can not find the information I am looking for. Attached is the example for the passanger side ETA; I am looking for the exactely the same info but for driver side.
Thanks!


From Board LocationTo Connector Pinb3c14k12e9g7i5Motor + terminal4Motor - terminal11

Sorry for messing up with the format. Try again:


From Board Location: To Connector Pin

b 3
c 14
k 12
etc.

Philippe, if the ETA is identical to the one on my 95 E320, I have the diagrams you need. I replaced the wires on mine last winter and I still have my notes.

__________________
95 E320 Cabriolet, 169K