|
|
|
#1
|
|||
|
|||
Help-Transmission Swap 4 Bolt to 6 Bolt
I am installing a 300D Turbo Engine/6 Bolt Pan Trans. in a non turbo car... There is a wire that runs from the kickdown switch under the accelerator pedal to the old 4 bolt pan transmission on the right side, bottom front(a small rectangular metal black box). The 6 bolt pan transmission does not have a place for this wire... What do I need to do with the wire???? Also the new transmission does not use the same speedometer cable.... Any ideas/comments/suggestions will be apprerciated...... Jim
__________________
James A. Harris |
#2
|
|||
|
|||
Did you ever get any response?
Jim,
I have just completed a similar 4 bolt tranny for a six bolt swap. I'm not worried about the extra wire, yet. But I'm stuck on the speedo cable. How did you solve this? I'm thinking of using a dremel to shave down the flat bar to a square, but it's a one shot thing and I'm not that confident.
__________________
1980 300SD "Gretchen" |
#3
|
|||
|
|||
Cable
I had a couple of cables and used the one that was right for the ttransmission and that also was right for the instru cluster.. Don't remember which was which but if you tell me what you need I will check... let me know about both ends.. Jim
__________________
James A. Harris |
Bookmarks |
|
|