|
|
|
|
|
#1
02-13-2008, 09:06 PM
|
|||
|
|||
|
adjusting ignition timing 88 190e 2.3 us
to whom it may concer,
i was just wondering if the ignition timing for the 190e 2.3 {us}88 model be adjusted manualy? if so. how is it done step by step, to what number of degree, where could i find the timing mark at the cranckshaft pully. the reason for asking is that i would just like to put the car in it's tip top condition. thanks. 
|
|
#2
02-13-2008, 09:10 PM
|
||||
|
||||
|
is not adjustable, it does have a base setting at 0 degrees top dead center
on the crank it os like this OlT, on the distributor there is a line / indicating tdc
__________________
1967 250 S 1967 280SE 1968 250S 1971 280 SE 1973 220 1974 280 S 1975 450 SEL 1976 220 D 1979 300SD 1983 300 SD 1985 230 TE euro 1986 280SL 1986 500 SEL euro 1986 190E 2.3 1990 300 SE 2003 C230 K 2004 C230 K 1987 560SEL 1987 300SDL now in canada 2005 C230 1998 C43 AMG Sold to DON 1993 190E 2.6 300TD Former daily driver Totaled current: R320 CDI Ram 2500 Cummins
|
|
#3
02-14-2008, 11:17 AM
|
|||
|
|||
|
Actually, it's probably adjustable with reference resistor. While you may not have the dial as it applies to euro vehicles in general, you might still have a connector with resistance plug on it. Different resistance values control the timing. This info applies to 6 cyl motors but I imagine it's the same for a 4. The second attachment shows the USA version.
Last edited by designo?; 02-14-2008 at 11:25 AM.
|
 |
| Bookmarks |
|
|
Linear Mode
