|
|
|
|
|
#1
02-27-2008, 04:28 PM
|
|||
|
|||
|
1994 Mercedes C280 part installation cost
Hello members.
1. Can someone tell me the labor cost to install front tyrod/tirod ends(left and right). the little tyrods that looks like a hammer head. 2. Also, the cost to change the engine drive belt.(it's one single long belt that controls everything that is propelled by a belt) Note: Parts are not included in this labor estimate. Thanks. tgifgemini. |
|
#2
02-27-2008, 05:09 PM
|
||||
|
||||
|
That's a tough question...
I just had one tie-rod replaced on my 1987 300D Turbo and the labor was $38 (about 1/2 hour of work)...
I replaced the belt myself...Just loosen the tensioner (or remove it if necessary) and fish it in according to the diagram...about 1 hour with rest stops ...and I didn't remove the fan or the shroud, but it's tight in there! The Tenor Man
__________________
Currently Driving..... 1987 Mercedes Benz 300D Turbo - Daily Driver. 2004 Buick Rendezvous...Smaller than it looks! 2005 Mitsubishi Galant - Not bad for a tin box...Lousey Seats Past Vehicles..... 1994 Dodge B-250 Van- GAS HOG..Succumbed to rust! 1989 Mercedes Benz 260E - Totaled but no one injured. 1977 Mercedes Benz 240D - Loved it, but SLOWWW! - Succumbed to RUST! 1976 Mercedes Benz 240D - Same as above! - 1975 Mercedes Benz 240D - Same as above! |
|
#3
02-27-2008, 05:14 PM
|
|||
|
|||
|
Thanks T man.
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
