|
|
|
#1
|
|||
|
|||
2000 c230 wont shift from park
We have a 2000 c230 with 87k miles ...
It will not shift out of park (while pressing the brake). I can manually override with the pen in shifter trick to put in gear, but once you put it back in park it locks and unable to shift (unless I manually override). Does it have a neutral safety switch????? FYI...this is the 1st problem I have ever had with the car, Thanks geo |
#2
|
||||
|
||||
Typical floor shift module failure. If the park release cable is hooked up and working, replace the FSM.
__________________
1980 500SE/AMG Euro 1981 500SEL Euro 1982 380SEL 1983 300TD 1983 500SEC/AMG Euro 1984 500SEC 1984 300TD Euro 1986 190E 2.3-16 1986 190E 2.3 1987 300D 1997 C36 AMG 2003 C320T 4matic past: 1969 280SE 4.5 | 1978 240D | 1978 300D | 1981 300SD | 1981 300SD | 1982 300CD | 1983 300CD | 1983 300SD | 1983 380SEC | 1984 300D | 1984 300D | 1984 300TD | 1984 500SEL | 1984 300SD | 1985 300D | 1986 300E | 1986 560SEL | 1986 560SEL/Carat | 1987 560SEC | 1991 300D 2.5 | 2006 R350 |
#3
|
|||
|
|||
Would be nice to view codes in the ESM. Bad brake light switchs are the common easy solution and will trip a code.
A cup of coffee into the shifter will also do it.
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician |
#4
|
|||
|
|||
Diy or shop???
Quote:
Thanks 4 your input.. is FSM something I can DIY and if so can I purchase part online(where?). and the same for brake lamp switch Yes we did spill a cup of coffee on console, I have a feeling its going to be a really expensive cup of starbucks....... more like hundred, or thousandbucks.... |
#5
|
|||
|
|||
I priced an ESM for a 210 chassis on Friday and MB list was $488. The part number is different for your car so it will likely have a different price.
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician |
#6
|
|||
|
|||
Quote:
Took car to local dealer here in Carlsbad CA, Hoehn Mercedes-Benz. They wanted to replace shifter, stop lamp switch and had a few recommendations. They wanted over 1k to fix and with other recommendations it would be over 2900.00. So I took next logical step and did a little research, check out the forums online and I was puzzled..to why if shifter was fried, then why was it not in limp mode. I purchased a new stop lamp switch and replaced it today.. And Voila the car shifts.. |
#7
|
|||
|
|||
You're welcome.
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|