|
|
|
|
|
#1
06-22-2008, 11:42 AM
|
|||
|
|||
|
p0715 + limp mode changed electrics
I had code p0715, After reading all over i changed the electrics (trans plate) my 13 pin connector was leaking, car in limp mode. Now i have the same code. I had the battery disconnected all day. Do I need the etc reset or should it reset itself. It is still in limp mode with the same p0715 code. Is there something I could have done wrong or not done to cause this? The repair was pretty straight forward.
1999 E320 4-matic 
|
|
#2
06-22-2008, 12:10 PM
|
|||
|
|||
|
That code is an OBDII code, you will have underlying trans codes that only SDS or similar quality sacnner can read. They must be erased before trans will work.
__________________
Terry Allison N. Calif. & Boca Chica, Panama 09' E320 Bluetec 77k (USA) 09' Hyundai Santa Fe Diesel 48k (S.A.)
|
|
#3
06-22-2008, 02:24 PM
|
|||
|
|||
|
So, will the trans codes that are stored will cause the odbII p0715 code to pop back up until the etc is reset? If I leave the battery off for a few minutes the odbII code goes away for a minute then comes back making me think something is still wrong. I just don't want to drive to a dealer to find out that I have to drive back at 15 mph to repair something else.
|
|
#4
06-22-2008, 02:31 PM
|
|||
|
|||
|
The trans can't work until the orig codes (the ones you can't view) are cleared using SDS. It'll remian in limp mode until then. Afterwards you'll find out if it was repaired properly, or not.
__________________
Terry Allison N. Calif. & Boca Chica, Panama 09' E320 Bluetec 77k (USA) 09' Hyundai Santa Fe Diesel 48k (S.A.)
|
|
#5
06-22-2008, 06:34 PM
|
||||
|
||||
|
Disconnecting the battery will not clear codes for a 722.6 transmissison,clear codes with a MB compatible scanner
__________________
Steve Cattaneo www.mastertechtrans.com 03 SL500 02 MB AMG 87 560 SEC 87 300D 928S 83 85 928 S2 EURO
|
 |
| Bookmarks |
|
|
Linear Mode
