|
|
|
|
|
#1
07-15-2008, 07:41 PM
|
||||
|
||||
|
OBD I diagnostic system-how to read it
RE: a 1995 E320, is there a brief tutorial someone can point me to on how to use/read the on-board computer fault codes that may be stored? I found the interface, but how do you activate it and where can I find what the codes mean? Thanks.
|
|
#3
07-15-2008, 08:37 PM
|
|||
|
|||
|
__________________
A Dalton
|
|
#4
07-15-2008, 10:04 PM
|
||||
|
||||
|
Wow!
That is thorough, thanks. I'm used to working on OBD II with a scan tool and Volvos with OBD I. Pre-1996 Volvos allow you to also read climate control/emission control/ABS/transmission/power seat issues etc. with just the device in the engine bay. MB pre-1996 only supply engine codes? What do you do if the ABS light is on? How do you know which is the suspect wheel? What about the transmission?
|
|
#5
07-15-2008, 10:12 PM
|
|||
|
|||
|
__________________
A Dalton
|
|
#6
07-15-2008, 10:24 PM
|
||||
|
||||
|
Kool!
THAT is invaluable. I didn't read the whole thing yet, but i"m going to print that out - thanks again. Whereabouts in NH are you?
|
|
#7
07-15-2008, 10:34 PM
|
|||
|
|||
|
Mass border.....
Brick House Blues Room Milford, NH
__________________
A Dalton
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
