|
|
|
|
|
#16
08-02-2008, 09:25 PM
|
|||
|
|||
|
Yeah. I think someone yanked the N/59 module.............sucks..
Hey, look at it this way..they converted it to Fed Vesion for ya ....LOL Do you live in an Emmissions Inspection state??????????/
__________________
A Dalton 
|
|
#17
08-02-2008, 09:37 PM
|
|||
|
|||
|
PA - Southcentral region
All they do is a visual check (probably of the CAT) and a gas cap check so I think I am good.
__________________
Brian G. 1994 E320 Wagon with many warts SOLD 1995 E320 Wagon with a beauty mark or two FOR SALE
|
|
#18
08-03-2008, 05:25 PM
|
|||
|
|||
|
Research so far.
Based on the codes taken and research here and elsewhere, I have several obvious items to deal with. Pin 8 Code 4 - MAF sensor trouble. I will get some MAF cleaner and try to clean this out this week and hopefully wipe this code. I also found a link on how to troubleshoot the unit from another thread - http://www.ms-motor-service.com/ximages/pg_si_0079_en_web.pdf Code 25 - CMP sensor bad - Haven't figured this out yet. Code 33 - Max retard setting reached - symptom of other problems or reaction to MAF or CMP sensor troubles? Code 42 - CAN communication from EA/ISC module faulty - is this due to the CA to Federal conversion? Pin 14 Code 4 - Stop lamp switch error? Sounds like I need a replacement switch. COuld this be triggering the ABS light? Code 11 - Fuel Shutoff to LFI-SF module?? GOt an HM system so I must be looking at the wriong code sheet. Pin 6 - Was not able to find code sheets for my model but this is either the SRS or ABS module. Tasks in short term Replace Stop Light Switch (or check wiring first) Clean MAF
__________________
Brian G. 1994 E320 Wagon with many warts SOLD 1995 E320 Wagon with a beauty mark or two FOR SALE
|
|
#19
08-03-2008, 05:48 PM
|
|||
|
|||
|
Just clear 6 and reset. ..you had a voltage supply interruption.
It is not ABS,....it is AB [air bag/srs]
__________________
A Dalton Last edited by Arthur Dalton; 08-03-2008 at 07:37 PM.
|
|
#20
08-03-2008, 06:28 PM
|
|||
|
|||
|
All those codes (on pins 6, 8, and 14) came back after I cleared each of the earlier ones and after a 30 min test drive.
Should I still go ahead with the Stop Lamps Sw and MAF clean?
__________________
Brian G. 1994 E320 Wagon with many warts SOLD 1995 E320 Wagon with a beauty mark or two FOR SALE
|
|
#21
08-03-2008, 07:36 PM
|
|||
|
|||
|
Yes.
My last post simply tells you what was found for pin 6. You said you did not know what the codes for that pin were and you also thought they were a possible ABS code..that it what I was addressing..
__________________
A Dalton
|
|
#22
08-03-2008, 09:26 PM
|
|||
|
|||
|
Thanks for all your help this weekend. I wouldn't have gotten a 1/4 as far as I did without your guiding hand.
Gonna work on these items over the next week and will report back as I get results or failures. Thanks.
__________________
Brian G. 1994 E320 Wagon with many warts SOLD 1995 E320 Wagon with a beauty mark or two FOR SALE
|
 |
| Bookmarks |
|
|
Linear Mode
