Thank you MB DOC I was able to get wiring diagram for the wiring harness that goes from this connector called x22/1 and someone had the wire instead of going to the starter solenoid connected to ground on transmission (what a mess) In any case I connected this wire to starter and now when I try to start the car now the car will crank and rotate but it will not start as in run. I checked for fuel pressure and there is none. I checked the fuel pump and it is not getting power. I put power manually to the fuel pump and it pumps gas once manually hooked up but the car still does not start. When I try to start the car the mirror lights flash (both red and green) but not as I try to start but when I turn the key off. How do I check if the alarm is stopping the power to fuel pump? The remote key locks and unlocks the doors and I do not understand if the alarm is working or not or if it is preventing the start. The red and green wire that goes to fuel pump from k40 or alarm module is not giving power. Can someone help me what is the problem or help me troubleshoot. I read a post saying something about the crank position sensor does that have to do anything with the power supply to the fuel pump or letting the fuel go to cylinders by giving a signal to injectors? How do I check if the ecu is good? thanks for anyones help