I posted this question in the diesel section a week or so ago as thats where i usually am reading,however i got only one reply.I tried the suggestion that the roof moulding is held on by clips and to just pry it off,i tried a little to do that but really have not tried very hard as i am afraid i will damage the moulding. These are the two mouldings that start down near the bottom of the windsheild and run down both sides of the roof almost to the rear window
I need to repaint the roof as the clear has completely failed and it actually has rust in a couple of small areas on the sun roof. These mouldings have a rubber gasket under them and i really feel that i could do a much better job on the roof if i could get these off.I have looked at the Russian parts catalog but did not find any useful info there and since i am on dialup icannot get anywhere with the MB epc. any and all help will be greatly apreciated. Don