|
|
|
#1
|
||||
|
||||
W126 Sliding roof motor question
I tried the search, but did not find what I needed.
I have the sunroof motor out for cleaning of the tubes. The threaded shaft with the large nut is very loose in and out ( push-pull on the shaft). There is maybe 4-6mm of clearance. There is no perceptible clearance in the rotational direction. The reason for the maintenance is that the motor failed to move the roof panel, and a loud burping/ buzzing noise was coming from the trunk. I assume ( ouch!) that the noise is the clutch slipping, or the gear stripping over the cable. Is that clearance excessive? Can it be adjusted? Am I better off with a junkyard replacement motor? Thanks, If there is a thread where this has been discussed, please just post a link.
__________________
1982 300SD " Wotan" ..On the road as of Jan 8, 2007 with Historic Tags |
Bookmarks |
|
|