Hi Guys,

I finally pulled out the instrument cluster this afternoon so that I could count the teeth on the odometer. E1 was disintegrated, but I counted 16 teeth on E3 for my particular car.

Anyhow, I started to put the cluster back in and ran into a problem. I don't recall if there was something connected to the 2-pin rectangular connector just above the right side of the outside temp gauge, of if you like, to the right of the round speedo signal connector. I looked around in the dash but couldn't find a matching connector, but could have sworn that I did disconnect it, though all the gauges seem to be working so far...

Anyone know what that connector is for, or if it's even used? I'll be digging in again when my gears get here, so any help would be appreciated!



edit: reattached picture