thanks in advance, I was working on my E420, 94, and found this plug but couldn't figure out where it goes. I'm attaching the pic, if someone will be kind enough to let me know what this plug is for and where it should plug in... thanks
this is right behind the driver's side head light area...

Attached Thumbnails

 

__________________
Whether you think you can or cannot, Either way you're right!. by Henry Ford.

looks like the intake air temp sensor connector that's sits in the hose to the aircleaner. good luck, chuck.

strangely enough there's no intake manifold temp sensor on the driver's side... is it supposed to be attached to the air intake hose that has foam covering ? I searched and found out this... is this the part where the connector is supposed to plug in..where should this part be located ? thanks.

Attached Thumbnails

 

__________________
Whether you think you can or cannot, Either way you're right!. by Henry Ford.

EXACTLY where i don't remember, but i was all over an e400 this summer, chasing a left headlight washer/wiper problem, so i was in that corner a lot. i 'm pretty sure it's in the non-insul hose. the picture of the sensor looks right. otherwise, sorry, i could be wrong. good luck, chuck.

The sensor is held in the cover behind the headlight. The cover is where the flex hose connects to. Inside there should be a special clip to retain the sensor. Its usually missing and you need to fabricate another method of retention... think zip-tie.

__________________

90 300TE 4-M
Turbo 103, T3/T04E 50 trim
T04B cover .60 AR
Stage 3 turbine .63 AR
A2W I/C, 40 LB/HR
MS2E, 60-2 Direct Coil Control
3" Exh, AEM W/B O2
Underdrive Alt. and P/S Pulleys,
Vented Rear Discs, .034 Booster.
3.07 diffs 1st Gear Start

90 300CE 104.980
Milled & ported head, 10.3:1 compression
197° intake cam w/20° advancer
Tuned CIS ECU
4° ignition advance
PCS TCM2000, built 722.6
600W networked suction fan
Sportline sway bars
V8 rear subframe, Quaife ATB 3.06 diff