Hey guys,
I am about to replace my front and rear shocks on my 1980 300SD with a new set. I want to start on the front shocks. I opened the hood and I see where the shock towers are located in the engine bay.
Each shock tower has 2 nuts on the top. How do I remove these nuts? I used an adjustable wrench to hold the top of the shock tower while I attempted to turn the 2 nuts with a box end wrench. The box end is thick enough where it is actually locked onto both nuts at the same time. However, they are not turning..... I am confused? Am I doing this right?
08-26-2012, 07:52 PM
Threaded Mode
