|
|
|
|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
how are you guys running megasquirt triggering your tach signal?(fuel only)
ok i keep running into a issue im getting no tach signal to my megasquirt the shielded wire is connected to the negative side of the coil but im getting nothing at all this issue has really got me stumped. im using megasquirt 2 v3 just trying to set it up for fuel only.
|
#2
|
|||
|
|||
What engine? What year? What ignition system?
I'm currently using the "Hot Spark" points elimination kit (essentially a "Hall Effect" pick up which mounts inside the distributor) on my '72 M115 and on my '74 M110. I'm picking up the tach signal directly from the negative side of the coil. On my '85 M117 with the stock ignition system I'm also getting the tach signal from the negative side of the coil. Which version of the firmware are you using? If it is V3.x or above you must set the pick-up choice to "basic trigger" in the ignition set up choices as the default setting is "trigger wheel"
__________________
“Whatever story you're telling, it will be more interesting if, at the end you add, "and then everything burst into flames.” ― Brian P. Cleary, You Oughta Know By Now |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|