1995 E420 crank sensor replacement

[COLDSTART]

Not sure if anyone has had to do this job ,it is a difficult one at best ,the stainless casing on the sensor would not come out had to remove the aluminum part that holds the sensor put it in the vise and scrap it out bit by bit ,I made the hole slightly larger for the next sucker that has to replace it so it will just pop out. This was the car I posted a few weeks ago that run perfect until it warmed up the would miss and die. The sensor made it run much better but would not take a lot of fuel would start to miss again. today I cleaned the caps and buttons and it works much better again .to get 100% I will replace them with new ones ,I am going to replace the plugs even though the are new they are platinum bosch and I have not had good luck with them , I will put in NGK BKR5ES unless some one know of a better combination ,thanks