|
|
|
|
|
#1
03-30-2002, 04:48 PM
|
|||
|
|||
|
380SL Idler Arm rebuild Q?
I've looked at rebuilding the idler arm on my 380 and the top of the big bolt hits the (starter it looks like) before it will come all the way off. I suppose that if I get the bushing mostly out I can get enough tilt to get it out. I've read that you have to take the exhaust loose on some models-True?
Any advice is appreciated. J. Boggs 
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY page, Introduction to Idler Arm Rebuild | BoostnBenz | Diesel Discussion | 19 | 08-02-2013 03:43 PM |
| Idler arm rebuild; grease it? or not? | 240 Ed | Diesel Discussion | 14 | 02-27-2011 12:57 AM |
| W126 idler arm bushings | sixto | Tech Help | 5 | 01-26-2011 03:26 AM |
| Stupid Question about Tie Rods and idler arm | WANT '71 280SEL | Tech Help | 2 | 09-02-2003 12:09 AM |
| idler arm / exhaust and ball joint | 1992300e | Tech Help | 45 | 02-24-2003 10:36 AM |
Linear Mode
