1998 e320 No wipers/turn signal/washer

[mespe]

Hey,

Hey to me is this 1998 e320. Wipers, washer and turn signal doesn't work, High Beams work fine.

I just got this car running and have never really driven it. Looks like some PO tried to remove the steering wheel and gave up, so it might be the combination switch. (Tore up the steering wheel in the process I suspect)

an the combination switch be tested? There are only 6 pins on the connector so it shouldn't be that hard to figure out. Oh what it's a Mercedes,,,

[RichardM98]

Check fuses first of course. Removing the steering wheel can take some effort since the mounting bolt usually has threadlocker on it. See DIYs here and elsewhere for removal. Probably easiest to just replace it since it's not a on/off switch on a CAN bus car. FYI- Don't put key in ignition with airbag removed.

[mespe]

This is pretty new to me. Already put key in igntion and turned to on with airbaq disconnected. Perhaps a whoops, perhaps not, as I have access to a SD connect.

I went to check fuses, but there is no fuse designation sheet in the fuse box in the left rear of the engine compartment.

Haven't as of yet found fuese designation for a 98 e320.

Which fuse should I check?

[mespe]

Got er figured out,,, fuse 41 was missing,,, it was pulled by the PO because the right turn signal wouldn't turn off. So looks like I need a new combination switch

[RichardM98]

There are 3 fuse panels in the W210. 1) under the hood, 2) left end of dash (door must be open to access) and 3) under right rear passenger seat. There should be be fuse cards at each location.

Jpegs below in case anyone wants them.