Bolts attaching transmission fluid pan to the transmission should be torqued to 8 Nm (6 ft/lbs). It's possible that your pan is deformed from previous over-torqued bolts in an attempt to stop the leaking. The pan gasket and properly torqued bolts provide a tight seal. Best to remove the pan and check the condition of the flange surface with a straight edge. Adjust, as required, so the flange is perfectly flat and will provide a tight, unifrom seal when the pan is installed.

__________________
Fred Hoelzle

Thanks Fred I will try that,when I was putting the new gasket on the pan it was a sloppy fit hmmmm!