![]() |
|
|
|
|
#1
|
|||
|
|||
Brake diaphragm travel sensor installation - won't go in
I'm replacing the brake booster on my W140. Trying to install the diaphragm travel sensor in the new booster. I can't seem to get it to go in far enough for the circlip to engage the notch in the sensor. Anybody know a trick to this? Are they usually this difficult?
I have the O-ring up on the little step where I think it belongs. It's close, but not quite there.
__________________
Jay 1998 S320 |
#2
|
|||
|
|||
Never mind. Just needed a little more testosterone, apparently. I can't figure out how to delete this thread or I would. :-/
__________________
Jay 1998 S320 |
![]() |
Bookmarks |
|
|