![]() |
|
|
|
|
![]() |
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
So I'm tooling along one morning and "bing"on goes the ABS, ESP and XXX not working, look in the manual.
Code was read and says module electronics bad. I have found the complete abs pump and control module for sale everywhere, but is it possible to replace just the dynamic control module, as shown in this how-to: ABS Dynamic Control Module Replacement Follow these step by step instructions for replacing the ABS dynamic control unit Applies to: C350 (2007-14), C180 (2007-14), C200 (2007-14), C230 (2007-14), C250 (2007-14), C280 (2007-14), C300 (2007-14), C320 (2007-14) Its a 2008 C300 4MATIC Luxury I prefer not to spend $600 + for a rebuild...... if it can be avoided...any help is appreciated ![]() |
#2
|
|||
|
|||
Post a Comment just below the article and someone will get back to you with more technical help. Best of luck!
![]() -Dmitry |
#3
|
||||
|
||||
"2008 C300 ABS, ESP lights on, replace just Dynamic control module?"
Yes, it is a plug and play unit. When the ABS control module failed on my 2001 SLK230, it caused the ABS pump to run continuously. I had to remove the fuse to get the pump to stop running. New A170 545 01 32 Module: $1,250.00 I found a wrecked 2001 SLK230 near me and the ABS pump assembly looked in good condition, so I purchased the entire unit for $150.00. I swapped the control modules and my problem was resolved and the ABS/ESP lights did not come back on. Good luck. Pictures of used unit: ![]() Here is the module after I removed it from the ABS unit I purchased. ![]() Module installed on my car, as you can see, it's a tight fit. If you move the fuse cover and surround cover, it gives you just enough room to remove and install a new module. ![]()
__________________
![]() 1993 190E 2.3 2001 SLK230 1971 LS5 (454) Corvette Convertible |
#4
|
|||
|
|||
Well boys and girls, replacing the Dynamic Control Module on a 2008 C300 means having to get a NEW (not rebuilt) unit and having the VIN written to it. It cannot be overwritten, eliminating your getting a used unit. Unless there is a magic way to erase the current VIN in a used unit, one is forced to buy a new one from MB and have a dealer install it.
Bend over...... |
![]() |
Bookmarks |
|
|