Hi to everibody
I hope someone can help me.
I am fighting with steering Wheel.
i follow all i can find on internet but this 10 mm allen bolt do not want to loose.
I tried to hammerin , to put wd 40, to heat a little bit but nothing.
Probably some of the previous owner did somethingh bad with this nut.
i would like to know if someone has picture of this 10 mm allen as i think i need to cut with dremel and after see what happened.
Thanks a lot
Alberto
I have w 124 1992 with airbag

Are you trying to remove the steering wheel? I have used a hex socket with a breaker bar to remove the one bolt that holds the wheel to the steering column. If you are just trying to use an allen wrench you will not have enough leverage to break the bolt loose.

I finally got loose this
I decided to heta alot with small torch very small
I used 2 big bat to block Wheel and long lever but it was too tight as the allen already start to turn inside the place .
i hope the heat do not damage but no other way.
Thanks a lot
Alberto

Alberto; Get a new bolt before you replace the wheel. Also, I suggest you remove as much thread locker from the new bolt as you can to help in future removal.

Thanks a lot
do you have MB code ?
I would like to roder by internet if i found

This is the only listing I can find. Maybe you can ask them the PN:

Mercedes-Benz Steering wheel Mounting Securing BOLT W124 W123 W140 W126.. OEM | eBay

__________________
1998 C230 330,000 miles (currently dead of second failed EIS, yours will fail too, turning you into the dealer's personal human cash machine)
1988 F150 144,000 miles (leaks all the colors of the rainbow)
Previous stars: 1981 Brava 210,000 miles, 1978 128 150,000 miles, 1977 B200 Van 175,000 miles, 1972 Vega (great, if rusty, car), 1972 Celica, 1986.5 Supra