Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help




Go Back   PeachParts Mercedes ShopForum > Technical Information and Support > Tech Help

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 07-02-2002, 03:20 PM
jbishop123
Guest
 
Posts: n/a
Question 96 C280 Which O2 Sensor?

I had my 1996 C280 OBD Coded. A resulting code was a P0141 which according to my information is a O2 Heater Circuit Malfunction (Bank 1 - Sensor2). I think to correct this error code I have, I need to replace the after catalyst O2 Sensor. Is this correct? Is this an easy item to change out. I saw a O2 sensor tool available, or is it not neccessary?

Thank you for any additional information that can be given.
Reply With Quote
  #2  
Old 07-02-2002, 09:46 PM
Junior Member
 
Join Date: Dec 2001
Location: Westchester Co. , New York
Posts: 27
O2 Sensor #2 would be the After Cat O2 Sensor and would need to be replaced. The O2 Sensor Tool will make it much easier to get out, it is in a pretty tight place behind the cat between the 2 pipes exiting the cat. If it wasn't in that location, then a standard 22mm wrench would take it off with out much of a problem. The plug for the O2 Sensor is under the car near the sensor, so you don't have to worry about pulling the carpet up to find the plug somewhere inside the car.
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 12:48 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2011 Pelican Parts - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page