|
|
|
|
|
#1
06-29-1999, 10:21 PM
|
|||
|
|||
|
Can anyone tell me how to replace the bottom hose on the idle valve? I am
replacing all the rubber to and from the idle valve but the hose coming off the bottom goes up underneath the fuel injection unit. Has anyone replaced this hose? Thanks in advance, Chris Prestridge 1988 190E 2.3 |
|
#2
06-30-1999, 08:46 PM
|
|||
|
|||
|
Yes, you have to reach under the intake and take out the hose with your hand from the front of the engine. It is not easy to get to and is tight to get back on. This hose will blow off and cause the engine not to run if you are not careful.
------------------ Benzmac: ASE CERTIFIED MASTER AUTO TECHNICIAN LEAD TECHNICIAN FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wagon rear suspension valve rebuild | lrg | Diesel Discussion | 11 | 10-04-2006 06:02 AM |
| W126 Valve Stem Seal replacement DONE! | donbryce | Tech Help | 19 | 07-28-2004 08:16 AM |
| Idle Control Valve 190E 2.3 Hose Part Number | Matt_Clarke | Tech Help | 1 | 10-19-2003 11:47 PM |
| idle control valve hose | jayhawk | Tech Help | 2 | 12-20-2002 11:35 AM |
| Valve cover exhaust hose "gooped"? | Rainman | Tech Help | 1 | 11-26-2001 08:48 PM |
Linear Mode
