|
|
|
|
|
#1
07-06-1999, 10:39 AM
|
|||
|
|||
|
I am trying to remove the cylinder head from a 220 (115 920) gasoline engine.
I have gotten pretty far, but the timing chain tensioners (big one on passenger side especially) are not allowing the head to come free. How do I get the tensioners off? Thank you, |
|
#2
07-06-1999, 09:01 PM
|
|||
|
|||
|
There should be small pins driven into the front of the head. If so they will have some threads and will pull out and hammer back in when completed. I'm guessing that you are speaking of the chain rails when talking about the tensioners.
------------------ Benzmac: ASE CERTIFIED MASTER AUTO TECHNICIAN SERVICE MANAGER FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OM603 - oil leak from exhaust port with new head! | gsxr | Diesel Discussion | 40 | 01-29-2019 10:52 AM |
| Help! Engine Dead???? | Breckman99 | Diesel Discussion | 17 | 05-09-2005 11:26 PM |
| Head gasket replacement | MarkM | Diesel Discussion | 16 | 11-02-2001 12:07 PM |
| Help!! 380SE head leaking OIL? | barndoor | Tech Help | 11 | 10-31-2001 01:19 AM |
Linear Mode
