|
|
|
#1
|
||||
|
||||
190 Flex disc r/r in progress right now -- help needed
1991 190E 2.6
-- front end on ramps, back end on jacks, wheels free to turn -- trans support removed -- bolts out of flex disc PROBLEM: -- I can't get enough movement to pull the driveshaft back for clearance to remove the old and put in the new disc -- I have read on the board about the "big nut" that may need to be loosened (not removed) to accomodate more movement. Where is this nut? OR, do you have another suggestion? EDIT 3 HOURS LATER: Ok, the flex disc metal couplings had "welded" themselves to the drive shaft. With a little, uh, persuasion it popped loose. I still had to lower the exhaust bracket so that I would have enough room to get the disc out of the hole -- you know where the splines (male part) goes into the drive shaft (female part). [enough, already, I'm getting worked up here :-) ] Now, let's just see if I can get it all back together. Rubber was fine, but the metal inserts were loose within the disc. Thanks mucho -- brookspw
__________________
1994 C280, dark green metallic 105k miles 1991 190E 2.6, Black 191,500 miles (sold to another forum member) 2003 Chevy Tahoe LT, Redfire Metallic 105k miles 1989 Mustang GT Cobra Convertible 43k miles Last edited by brookspw; 09-28-2002 at 06:11 PM. |
#2
|
||||
|
||||
I guess you found the big nut?
__________________
Jim |
#3
|
||||
|
||||
Down, boy! Just kidding. Nope, still have no idea what that is referring to. However, all I did (once I freed the disc) was to lower the exhaust shield a little, which gave the drive shaft a little more room to move and, voila, I had enough room to get the disc out and the new one in.
__________________
1994 C280, dark green metallic 105k miles 1991 190E 2.6, Black 191,500 miles (sold to another forum member) 2003 Chevy Tahoe LT, Redfire Metallic 105k miles 1989 Mustang GT Cobra Convertible 43k miles |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|