|
|
|
#1
|
|||
|
|||
I need to remove the instrument panel to get at the clock for repair. I've read that with a coat-hanger type tool you can insert it at the 9 and 3 O'clock positions an dpull on the IP. Is this so? Any trouble I an get in? It's an 88 420SEL
Thanks... ------------------ |
#2
|
|||
|
|||
The tool is much thinner and stronger than a coat hanger. It is a set of pullers. You do slide them in and turn them to catch the edge and be careful.
------------------ Benzmac: 1981 280GE SWB 1987 16V ASE CERTIFIED MASTER AUTO TECHNICIAN SERVICE MANAGER FOR 14 BAY FACILITY MERCEDES SPECIALIST 8 YRS PARTNER IN MERCEDESSHOP.COM |
#3
|
|||
|
|||
Good info....but where exactly you put the pullers in order to remove the IP ? I need to remove my speedo for repairs....Are there any precautions that the need to check other than " be careful"....
|
#4
|
|||
|
|||
Dash removal,
I'm not sure if the dash in your 420 is the same set up as my 300SD 126, but I did make the dash removal tool out of a coat hanger. I looked at the tool in the MB manual and fabricated mine. It worked fine. Then again, my vehicle is a little older, and the dash is probably not as tight, but it did work, with out paying the money for the factory tool. Best of Luck. Peter K ------------------ Wing_Nut 82"300SD |
#5
|
|||
|
|||
Try this link, they have the tools your looking for. $30.00 for a set. http://www.technictool.com/
------------------ Paul 1992 300TE 4MATIC |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
W124 Instrument Panel Removal Tools | dlssmith | Tech Help | 12 | 11-16-2004 10:49 PM |
W201 instrument panel cover removal | 190edude | Tech Help | 3 | 10-28-2004 04:08 PM |
clearing up some details on instrument panel removal on 87 300e | dirtysocks | General Information | 10 | 09-15-2004 12:21 AM |
Removal of Instrument Panel | lmtracer | Tech Help | 4 | 07-30-2003 05:04 AM |
190e Instrument Panel Removal | lburwel1 | Tech Help | 0 | 01-11-2002 08:44 PM |