5 years and 9 days. That just may be a new record.

Should I have pi$$ed off the forum police by starting a new thread before searching?

Euro Bosch headlight for 92 300E
 

Well I am definitely a dummy when it comes to putting these lights in .I have had them for more than 3 years with all the bulbs and new lock caps and a peice to stick into the washer bottle to keep it for leaking.

I want to take the wipers off and put the 260-E plane panels below. I could certainly use you help PM at krwaxb@yahoo.com I will give you my phone number. at your convenience so I can try this over the phone I will except a collect call.

Sincerely
Bob Geco

190E
 

I emailed importvision.com regarding installing in my 190E, I was told that their euro sets including corner lights ($205) are virtually plug and play-no need for anything else. Also, on Ebay there are Bi- xenon complete with corner lights for $389. They too require no other electrical plug, pins, whatever. Just plug and play. Can this really be true? anybody know?

the depos i used were pretty much plug n play. i did however use the original corner socket in the new corners, it was a tight fit to get it to twist it but it made it. my dot setup had a 3 prong corner bulb sockets, the depo ones were a 2 prong n didnt plug in.

back to my question, anyone know if i buy euro washer brackets if it will fit the bottom of the lights housing to fasten them, i was able to modfify the dot washer brackets on the drivers side but not the passenger side whick jumps a bit from the enging vibrations?

i'm glad someone bumped this thread b/c it just helped me figure out the wiring on my euros.