|
|
|
#1
|
||||
|
||||
Power Seat INOP....Wiring problem
My passenger seat will only move back and none of the other functions will work properly. I figured it was the motors so I removed the seat and put power directly to the motors and they all work perfectly.....but when I put it back in the car....I get the same thing....I can see the motor kick and try to move but it acts like there is not enough power to move the seat....if I take the small battery I used to bench test the seat and connect directly to the seat terminals....it works fine....
I started doing some electrical trouble shooting and found that there are 2 relays in the fuse panel that are energized and quite warm to the touch....When I remove either one of these relays then I loose all functions on both power seats.... So what up here? Is the switch bad? Are the relays bad? How are these seats wired? Does anyone have a wiring diagram? The driver' seat works fine.... Thanks Brian
__________________
1995 E300 Diesel 1994 E320 1999 C230K 1994 S500 W140 1990 300 SEL |
#2
|
||||
|
||||
FIXED IT!!!
It was the switch....I took the switch apart and cleaned all the contacts and it works fine now....it was a tedious job but not too bad.
However, I am still concerned about the 2 relays that are sitting there energized all the time and getting hot....is that normal? Thanks
__________________
1995 E300 Diesel 1994 E320 1999 C230K 1994 S500 W140 1990 300 SEL |
Bookmarks |
|
|