|
|
|
#1
|
|||
|
|||
How do you do it? (560 SEL)
|
#2
|
|||
|
|||
How much do you want to remove? If you are just wanting to reupholster the cover or replace the foam center you should lower the seat back so that the two seats backs aren't next to one another. With a screw driver pop the plastic cover off the shaft end and remove the large four groved nut. It takes a special tool I suppose but we have never needed it.
If you want to totally remove the armrest for good you probably want the shaft removed too. To do this remove the back cover of the seat. One screw at the bottom and the cover slides down. You will need the seat back all the way up for this. Once the cover is off the armrest shaft is available for remove. I don't remember how it held on but its not complicated. ------------------ Steve Brotherton Owner 24 bay BSC Bosch Master, ASE master L1 26 years MB technician |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Removing door lock tumblers - 300E | Zeus | Tech Help | 31 | 03-02-2004 01:51 PM |
how do you REMOVE a w123 armrest??? | Peyton300TD | Diesel Discussion | 7 | 10-25-2003 05:44 PM |
armrest and door handle leather/ steering wheel | MUYAMAN | Detailing and Interior | 3 | 07-18-2002 05:30 PM |
4 hour seat swap, armrest ? | sean 300D | Diesel Discussion | 7 | 05-12-2002 03:32 PM |
Do it myself: rebuilding Center Armrest.. | carman850 | Tech Help | 13 | 01-14-2002 12:10 PM |