|
|
|
#1
|
|||
|
|||
? Regarding Outside Temp Guage at Cluster
Just purchased an outside temp unit from ebay.
I did a search but could not find this question. Here's goes- The entire temp unit looks as if would simply slide into the cluster from the front. How is the unit attached behind the cluster? Is there a clip of some sort or is it screwed in? I tried pulling the cluster out today - Is there really that much force needed to do this? I could not get it to slide out. I may have been a little to cautious on the force I was using. Just felt that any more force would cause some damage. Any assistance would be appreciated. Thanks!
__________________
1993 190e 2.3 Spruce Green Metallic 62k original |
#2
|
|||
|
|||
I did this to my wife's W124 a while back. It should be similar to your 190E.
Check out the archives under OTG, or use this: Retro-fitting OTG to a W124 . Enjoy. Bazzman E200 Wagon 1994 |
Bookmarks |
|
|