Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Tech Help

 
 
LinkBack Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 05-08-2000, 09:38 PM
190E 2.0 Jason
Guest
 
Posts: n/a
Sorry for the dramatic subject, but I'm at wit's end. Any help would be *greatly* appreciated.

CAR: 1988 German-model 190E 2.0 Sport. 85k miles, US Emissions Pkg, CIS and all the same engine electricals as the US 2.3

SYMPTOMS: Surging/Stalling after cold start. Severe engine hesitation under low-rpm load following start (hot or cold). Injectors do not shut off on deceleration with any computer I've tried.

TESTED/REPLACED: New O2 sensor. New plugs. New cap & rotor. Wires OK. New Fuel Injector Seals. No vacuum leaks. New over-voltage relay (working). Fuel Pressure Regulator OK. Aux Air Slider Valve appears to be OK (9 Ohm Resistance). O2 voltage at idle = .56, full throttle 0.93, cruising 0.15. Coolant Temp Sensor OK. Fuel pressure OK. Engine running better than ever (9.6s 0-60 runs w/auto) and getting better mileage than ever (27hwy, 23 city).

REMAINS IN QUESTION: Electro-hydraulic Actuator, Engine Computer.

STRANGE THINGS: Voltage across Terminal 3 & Ground fluctuates around 6V with the throttle slightly pressed. Fully released (when switch is not actuated), voltage is constant 12.2V under *all* conditions. This did not happen with donor computer I substituted in, but engine still surged. Computer was from an '84, i.e. not an exact match. Is this 12.2V thing a "limp mode"?

When I unplugged the EHA, there was *no* difference in idle.

When the Aux Air Valve is unplugged, idle is glass smooth at 1200rpm. (750 with it plugged in, surging slightly when warm, massively when cold. Idle sometimes jumps to 1100 and stays there when warm).

Currecnt to EHA (with EHA disconnected) following cold or hot starts is 0.13A.

The car has spent 4 weeks total in 3 different shops (including the Dealership), and we're all stumped. I'm hesitant to spend any more money, but my next step is to replace the computer and the EHA. But will it help?!

REWARD: If you help me, I will love you forever, say nice things about you forever, and more importantly, not post any more long messages.

[This message has been edited by 190E 2.0 Jason (edited 05-09-2000).]
Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Idle Control Valve - 88' 190e 2.3L gards Tech Help 1 07-29-2003 12:55 PM
190E 2.3-16 parts for sale kiato4 Mercedes-Benz Used Parts For Sale & Wanted 2 06-25-2003 07:14 PM
Idle problems 1988 190e 2.3 Island Fred Diesel Discussion 0 09-28-2002 12:10 PM
'91 190E 2.3 rough, low idle - fixed sbourg Tech Help 0 08-19-2001 01:17 AM
very very rough idle on '85 190e and hard starting dug Tech Help 4 06-26-2000 02:57 PM



All times are GMT -4. The time now is 09:38 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page