|
|
|
|
|
#1
10-09-2003, 10:44 PM
|
||||
|
||||
|
Another CO Adjustment Question.
After correcting my CO adjustment a month ago everything was working just fine until a week ago when I noticed the engine was hard to start, hot or cold, and a slight rough idle as well. I decided to check my duty cycle reading again this evening and found it to be sitting at 92% flat!!
 Fortunately it is not running that lean, I can tell by the smell of the exaust. Is this a trouble code? I have tested the battery voltage, the OVP relay, the EHA and the idle air valve,,,, All of these seem to be functioning properly. What else should I be looking at??? Your suggestions will be greatly appreciated.Thanks! Adam
__________________
Current Stable: 01 ML55 AMG 92 500E (a few mods) 87 300E (lots of mods) 00 Chevy 3500HD Diesel Box Truck 68 18' Donzi Marine  06 GT i-Drive7 1.0 Mountain Bike (with GPS!  )PREVIOUSLY OWNED:83 300SD, 87 420SEL, 88 420SEL, 90 420SEL, 86 560SEL, 86 190E 2.3-16V AMG, 94 E320 
Last edited by ADAM BOURASSA; 10-10-2003 at 12:30 AM. 
|
| Bookmarks |
|
|
Threaded Mode
