![]() |
|
|
|
#1
|
||||
|
||||
Rear Power Seat Removal
I recently found an '83 or '84 euro 500SEL with the rear power heated seat. I would like to adapt this system to my 300SDL, however I'm unsure how to remove the rear seat from the SEL? I plan to take the bottom and lower frames out and put my pads/covers on them then I'll also take the trim, wires, and switches from the 500. I figure that since I'll have the car there in the junkyard I can pull anything off that car to make it work and I've emailed back and forth with a member here who did the same thing so I'm pretty confident.
In the owner's manual it shows how to remove the rear seat but it has a note saying if it's the adjustable kind to take it to your authorized Mercedes-Benz dealer, yada, yada, yada, (you get the point). So, how is this seat removed? Just out of curiosity, are these cars already wired for the motors, etc.? so I can just drop everything in? I assume not, but I'll keep my fingers crossed. Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power seat | piersbc | Tech Help | 8 | 05-23-2005 11:15 AM |
Swapping passenger seat for worn out driver's seat (power) on 300 SD | cmac2012 | Detailing and Interior | 0 | 04-17-2005 05:14 PM |
Installing power rear seat in 300SDL | LK1 | Tech Help | 0 | 09-07-2004 11:10 PM |
Bizarre problem with 560 SEL rear seat switches | rtoddholden | Tech Help | 3 | 11-27-2003 10:53 AM |
Audi Power Seat Question Help | Benz84 | Tech Help | 4 | 06-04-2003 10:20 PM |