|
|
|
|
|
#1
03-28-2004, 11:51 PM
|
|||
|
|||
|
one more sensor to identify
also needed this sensor identified, in the center of picture at edge of air cleaner there are two vaccum hoses that go to a sensor that screws into the manifold, what is it called? thanks in advance
|
|
#2
03-29-2004, 01:24 AM
|
||||
|
||||
|
Car model and engine type please.
__________________
Regards Warren Currently 1965 220Sb, 2002 FORD Crown Vic Police Interceptor Had 1965 220SEb, 1967 230S, 280SE 4.5, 300SE (W126), 420SEL ENTER > = (HP RPN) Not part of the in-crowd since 1952.
|
|
#3
03-29-2004, 09:39 AM
|
||||
|
||||
|
A thermo-vacuum switch, normally color coded to make identification easier. If you need to install a new one you may find it helpful to remove the switch and use the numbers on it in order to obtain the replacement. Probably wouldn't hurt to replace the specially formed rubber hoses as well.
You may find it easier on the fingers to do this while the engine is cold!!!  Good Luck
|
|
#4
03-29-2004, 01:35 PM
|
|||
|
|||
|
switch for 87 420 sel identification
sorry for got to say this is a 87 420 sel. thanks
|
 |
| Bookmarks |
|
|
Linear Mode
