I need to replace the lock housing, My key is stuck and I can't turn to the position to replace the tumbler, any advice?

how do I remove the lock housing?

Any and all advice is greatly appreciated.
CK

Do a search on ignition switch or steering lock at top of this page

__________________
MB STARS Master Guild Technician,17 years MB tech
14 years independent shop owner

Just did mine a few weeks ago.

You'll need to turn your key to the #1 position otherwise you're in for a long painful (or $$$$$) job.

1. Turn you key to the #1 position
2. Place a small wire into the holes
3. Pull ignition out
4. Reverse for installation of new tumbler (approx $100-150)

It's that simple if you can get it into the #1 postion. It'll take you about 15 minutes. Do a search as suggested by "MB STARS". I know there are some post with pics to guide you through this process.

If you can't turn the key to the #1 positon then you'll have to drill it out. If you take it to the dealers that will cost you approx $400-600.

__________________
JR
1986 Gold 300E 4Dr automatic

I concur with jrmd01.

If you can't get that key to turn, get your checkbook ready.

That happened to me last year, and the ignition had to be drilled out.

__________________
2008 E350 4matic / Black/Anthracite

------------------------------------
Gone but not Forgotten:
2001 E430 4matic, 206,xxx miles, Black/Charcoal
1995 E320, 252,xxx miles, Black/Grey
1989 260E, 223,00 miles, Black/Black