|
|
|
|
|
#1
09-13-2000, 02:28 PM
|
||||
|
||||
|
I've purchased thicker E55 swaybars to install in my E300 turbodiesel. The front went in fine, but removing the rear is looking darn near impossible. I've removed all mounting hardware and am trying to get the old bar out from between the subframe and vehicle underside. Is there a trick to this or will I have to lower the subframe to get this out???? HELP!!!
Jay Gibbs 
|
|
#3
09-13-2000, 06:17 PM
|
||||
|
||||
|
Many thanks for the response. My worst fears realized!
Jay
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Highly recommend replacing swaybar mounts | GregS | Diesel Discussion | 20 | 12-18-2003 04:13 PM |
| 1996 W210 Phone installation | TheWayne | Car Audio and Multimedia | 0 | 03-25-2003 08:33 PM |
| W210 Xenon Installation Repalcement | 01430 | Tech Help | 0 | 07-19-2001 11:42 PM |
| Anti-Roll kit (swaybar for 320CE) | patrik_the_swede | Tech Help | 0 | 05-15-2001 09:14 AM |
| W210 swaybar installation | Jay Gibbs | Mercedes-Benz Performance Paddock | 7 | 09-16-2000 02:11 PM |
Linear Mode
