Quote:
Originally Posted by bulldog001
I have a 5.6 in 87 560 sel and after purchaseing a MD factory repair manual on disk, after having mitchell on demand and after getting a hard copy of the MB 5.6 engine repair manual, where are the correct timing marks on the drivers side cam towers? one other question for now, does the fuel system control unit (AKA ECM) ground the temp signal for the cold start valve on pin # 7. Right temp going in wrong going to fuel pump relay. thanks for any help in advance. Note do not attempt these things on your own.
|
There are marks on the cam tower and on the sprocket. Make sure you have the lower crank marks aligned first. If your are off, skipped tooth, the valves and pistons will collide.
See this service manual for the cold start valve.
http://mb.braingears.com/126_DISC2/program/engine_560SEL.htm
http://mb.braingears.com/126_DISC2/program/Engine/107/M117_56/073-124.pdf
__________________
Regards
Warren
Currently 1965 220Sb, 2002 FORD Crown Vic Police Interceptor
Had 1965 220SEb, 1967 230S, 280SE 4.5, 300SE (W126), 420SEL
ENTER > = (HP RPN)
Not part of the in-crowd since 1952.
|