Quote:
Originally Posted by tobybul
.....I believe there's a lock ring washer somewhere that also needs to be removed.
Thanks again and please post if y'all think of sumthin' else..  |
George,
There is a lock/snap ring you need to remove to get the bearing out. Using the puller depends if the bearing is stubborn or not.
I know it is a PITA, but I only pulled the whole shaft out. But I guess you can slide it out of the spline. To get the drive shaft out you need to remove the mount and since your are replacing the mount you can get at the flex disk just use a "flex" socket and you should be able to get at it.
Good Luck.
Richard