Hi here what I found out .......

I check the cam sensor and it read perfect result was 830 ohms
I check the power supply from the EZL and the Diagnostic socket both perfect and even from the on and off ignition position

I need to test the ignition coil terminal 1 and 15 @ .3-.6 ohm
1 to 4 @ 7-13 kohm

I check/inspected most of the lines I could get to for shorts and found none

next I move to the fuel system

Does anyone know the proper wiring sequence for the ignition switch?

its a eight pin switch (these are my best guesses) I'm not really sure that it matters much with the wires with a question mark since they are all positive leads, but who knows .............I could just kick the guy that messed up the wiring in the dash.....and gage cluster

p/30 is green white wire
15 red black?
30 red
15x red/green?
30 red
50 purple
15t brown/purple black?
15r red yellow?