|
|
|
#1
|
||||
|
||||
92 190e 2.3 will not start...excessive fuel
Hi here what I found out .......
I check the cam sensor and it read perfect result was 830 ohms I check the power supply from the EZL and the Diagnostic socket both perfect and even from the on and off ignition position I need to test the ignition coil terminal 1 and 15 @ .3-.6 ohm 1 to 4 @ 7-13 kohm I check/inspected most of the lines I could get to for shorts and found none next I move to the fuel system Does anyone know the proper wiring sequence for the ignition switch? its a eight pin switch (these are my best guesses) I'm not really sure that it matters much with the wires with a question mark since they are all positive leads, but who knows .............I could just kick the guy that messed up the wiring in the dash.....and gage cluster p/30 is green white wire 15 red black? 30 red 15x red/green? 30 red 50 purple 15t brown/purple black? 15r red yellow? |
Bookmarks |
|
|