Quote:
Originally Posted by phinsup
Well it was the lower balljoint making the noise, however those balljoints are the freakin devil!
Anyhow all is well it a couple small exceptions, i had just had it aligned before i did all this, which was dumb, but now that i replaced all the tie rods, matched them up as best I could seems to be pretty close, but my steering wheel is offcenter, not gonna mess with it just gonna take it and get i aligned again since I have brand new tires on it, they should center the steering wheel for me.
|
I am going to be doing this job shortly as well. Do you know good sources for the tools to break apart the various joints in the front end? I have a couple different pickle forks but they tend to destroy seals.
My plan is buy used spindles/uprights and install the new balljoints on those so as to have them ready and minimize downtime. I did buy the tool to install the joints on my press so I am set there.