Quote:
Originally Posted by greazzer
Well, I totally chickened out because the pistons in the pump looked a little too close for me. I drilled them out and re-tapped 9mm x 1.25, which took out very, very little aluminum.
Any ideas on whether the torque will remain the same, e.g., 24-27 ft pounds. That is, with new bolts which are 9mmx1.25x40mm?
|
This was going to be my recommendation. Good job!
I'd use the rated torque, or less and loctite. The alum threads are the limiting factor, not the bolts.