|
Hi Again,
I am not sure where I mentioned it only took four hours to do the rear suspension. If I gave that impression, I appologize. It did take longer.
Another note - My differential mount did look good, so it was not replaced.Nor was the differential touched. Therefore the axle half shafts were only disconnected from the wheel side.
Even though I have already done the front end on my car, I would like to ask your opinion, or anyone else here on the forum - on a possible solution to a problem A friend is having with his (same) car.
Here is my question - When replacing the Bearing Bracket bushings along with the Track Rod bushing on my car, I had removed the bracket from the car completely to work on it. However, Is it possible (to replace only this one) bushing while the bracket remains in place, on the car ? Is there a puller that can do that job? I am talking about Item #16
Thanks I.A
|