Quote:
|
Originally Posted by gidpor
Hi Again,
Here is my question - When replacing the Bearing Bracket bushings along with the Track Rod bushing on my car, I had removed the bracket from the car completely to work on it. However, Is it possible (to replace only this one) bushing while the bracket remains in place, on the car ? Is there a puller that can do that job? I am talking about Item #16
Thanks I.A
|
Those bushings come out easily and can go in easily if you use silicone spray. Be aware though, that the large ball joint bushing may also be bad and need to be replaced. That requires determination, or a press. You would also need to clean out any rust from the inside of the aluminum bracket.
http://www.peachparts.com/shopforum/showthread.php?t=91934
__________________
Regards
Warren
Currently 1965 220Sb, 2002 FORD Crown Vic Police Interceptor
Had 1965 220SEb, 1967 230S, 280SE 4.5, 300SE (W126), 420SEL
ENTER > = (HP RPN)
Not part of the in-crowd since 1952.
|