|
|
|
#1
|
||||
|
||||
anit roll/sway bars material?
hi all,
I am going to make some anti roll bars for my 16v, i'm thinking 28mm front and 18mm rear. I have a friend who can bend them up for me.... I just wanted to check what material to use, I guessed steel rod of some sort but wanted to check what anti roll bars are usually made from? also, what are peoples opinions n 28front/18rear.....too big, too small, just right? thanks!!
__________________
Steve Howson http://www.markthomastrimming.com/storage/sigpic.jpg www.mercedes-cosworth.co.uk |
#2
|
|||
|
|||
I'm not sure, but I would imagine they're made of medium carbon plain steel that is subsequently heat treated (quenched and tempered) to a medium hardness for fatigue resistance.
__________________
95 E320 Cabriolet, 159K |
#3
|
|||
|
|||
Try calling Scorpion Racing on 02082114888 they make up special bars for Rangerover etc they may tell you where to start or even make them up for you. Regards Linds
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|