|
|
|
#1
|
|||
|
|||
I started my car and warm it up for about five minutes and
when I pulled off it went dead . And when you try to start it up again it would not start,it not firing what could be the problem . Can someone please tell me what to do about this problem . BCM494 thats you for all your help .The car is a 1985 and is a 380SE. I am sorry that I did not give all the info but it happens sometime . No it has not started sense that time. But I got a part and I have a question about it. What does it mean about (+) pin 1 (-) pin 5 = greater than 5 ohms . We have got a control unit , Idle . I hope that this is enough information on this . [Edited by bcm494 on 12-23-2000 at 03:29 PM] |
#2
|
||||
|
||||
Maybe its the kneuter valve.
Seriously, you might want to tell everyone what year and model your car is, before someone tells you that you need a new muffler bearing.
__________________
It is a truism that almost any sect, cult, or religion will legislate its creed into law if it acquires the political power to do so. Robert A. Heinlein 09 Jetta TDI 1985 300D |
#3
|
|||
|
|||
What did you "pull off"? Maybe if you "put it back on", the car will run. You sound like the people who "turn their car over". I did that once on a '54 Desoto and it broke the windshield and severely dented the roof.
Seriously, you have to give a much better description of your problem for anyone to help. P E H |
#4
|
||||
|
||||
Have you been able to start it since?
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
93 190E hard to start | drolyat | Tech Help | 5 | 06-30-2003 09:55 PM |
please help me diagnose a no start issue. 300SD(long) | RG5384 | Diesel Discussion | 8 | 06-14-2003 11:55 AM |
Please help me start a non-starting 240D. | ericnguyen | Diesel Discussion | 4 | 05-15-2003 09:58 AM |
Please help me start a non-starting 240D. | ericnguyen | Tech Help | 2 | 05-15-2003 07:02 AM |
1991 420SEL - beginning of a cold start problem | DieselGuy | Tech Help | 1 | 07-30-2001 03:56 AM |