|
|
|
#1
|
|||
|
|||
B2 Question !!
I tore a hole in the rubber seal that holds the b2 piston bushing in place. I put the car back together, and drove it, and it ran fine, but... IS there any problems that will occure becuause of this??? I really need to know. If there is, I will redo the job. Thank you
|
#2
|
||||
|
||||
The seal is critical to the release of the B2 band, with a leak the band will not fully release and drag. The release oil is also used for the 3- 4 shift.
|
#3
|
|||
|
|||
I was driving the car yesterday, and I had to come to a sudden stop, when I went to go again, I had no foward gears at all. There were no noises that I heard, it just wouldn't go. I checked the b2 piston, its still all in tact. Does this sound like something that could occur frorm the seal having a hole?
|
#4
|
||||
|
||||
Absolutely, the seal is leaking. While the piston is out, also check the T seal on it for any damage.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
83 300CD tranny modulator question | freesprung | Tech Help | 0 | 04-07-2004 10:10 PM |
Trouble Codes Question | talons40 | Tech Help | 2 | 08-22-2003 02:36 PM |
Center Console Question | hippie_elmo | Vintage Mercedes Forum | 2 | 02-01-2002 11:47 PM |
190E tire question | cossie | Mercedes-Benz Wheels & Tires | 14 | 01-31-2002 05:49 PM |
C220 Oxygen sensor question | chandrab | Tech Help | 0 | 01-12-2002 04:57 PM |