|
|
|
|
|
#1
07-27-2005, 04:01 AM
|
||||
|
||||
W126 tierods... load 'em with grease?
I'm planning to toss on new rods on the SDL today (Wed) or tomorrow and have a few quick questions regarding them...
It appears the end links can be potentially filled with chassis grease but I can't confirm this.  If this is so, how do I go about this as there are no Zerks on there. Anything else I should be aware of before getting into this aside from getting an alignment done ASAP? Thanks
__________________
I'm not a doctor, but I'll have a look.  '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG] 
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| marine trailer grease for wheel bearings? | odie | Diesel Discussion | 20 | 11-24-2004 03:57 PM |
| packing bearings | Robert Davis | Off-Topic Discussion | 7 | 10-06-2003 03:16 PM |
| Wheel Bearing Removal | Cazzzidy | Diesel Discussion | 9 | 08-06-2003 06:41 AM |
| W126 ('88 420 SEL): insufficient load range for front tires | Bob Boyer | Mercedes-Benz Wheels & Tires | 9 | 09-06-2002 02:31 PM |
| W126: grease -point hole above upper front control arm mounts | Robert Boyer | Tech Help | 4 | 12-07-2001 10:25 PM |
Threaded Mode
